Низкий погрузчик

MÜLLER-MITTELTAL 3-Achs-Tiefladeanhänger

Extract from the equipment. Complete equipment on request.

Extract from the equipment
* Hinged cover (hot-dip galvanized) for the toolbox in the bogie platform
* 1 all-round beacon (hazard warning light), removable, incl. holder and installation
* Warning package for exemption permit § 70 StVZO
* GIGANT axles 17.5"
* Extension by approx. 500 mm to approx. 6,500 mm deep loading platform length
* Mechanical equalization unit with parabolic springs
* Rear La-Si package: 2 UVV lashing eyes approx. LC 6,400 daN on the bogie platform
* Front left and right on the main frame
* 4 UVV lashing eyes approx. LC 13,400 daN suspended in the outer frame, of which
* 2 in front of the small offset on the DG platform, 2 in front of the rear carrier.
* 6 UVV lashing rings approx. LC 10,000 daN swivel and lowerable in all directions
* loadable, 2 of which after the small offset, 2 in the middle of the low loading platform
* 2 between the rear axles
* Wooden floor in clamped design (if technically possible)
* Galvanized folding boom and wooden planks for widening (not on the rear slope)
* Plank support under the chassis in longitudinal direction
* (track width of the load must not exceed 2,500 mm)
* Excavator stick support over rear axle continuously up to the end beam,
* Total length approx. 2,100 mm, cross member conically offset at the drive-on slope
* Width top/bottom approx. 780/400 mm, height: approx. 170 mm
* 2 pairs of lashing eyes approx. LC 6400 daN in the excavator stick support on the side of the longitudinal frame
* Approx. 300 mm from the front and approx. 200 mm in front of the slope firmly welded, galvanizable
* Spare wheel holder under the chassis, without spare wheel
* Tool box made of black powder-coated sheet steel, lockable
* Dimensions approx. W=650 x H=300 x D=600 mm (approx. 45 kg payload with even
* loading) on the right in the direction of travel
* Drawbar approx. 150 mm cranked with swivel drawbar eye 40/50 (without 8° eye, note coupling height),
* Basic length approx. 1,800 mm
* Attention: The U-protection of the truck must be in front of the coupling point, otherwise there is an increased risk of collision!
* increased risk of collision! D = 125 / 160 kN
Bcsgjd2Xhgg

Paintwork
* Single color paint finish in RAL 3002 carmine red
* Ramps hot-dip galvanized
* Attachments according to manufacturer's choice
* Rims in silver

Towing vehicle
* Coupling height: standard approx. 840 - 1,025 mm unbel
* Electrical system: 24 volt, 15-pin
* Compressed air: red/yellow
* Drawbar approx. 40/50 mm Ø

Объявление было переведено автоматически, в связи с чем могут иметь место некоторые ошибки перевода.