Кромконаклеивающий станок

HOMAG KAL310/7/A20/S2

Односторонний кромкообрабратывающий станок
производства: Homag
тип: KAL310/7/A20/S2
год выпуска: 2004

- Верхний прижим с клиновым ремнём и с электроприводом,
электромоторная регулировка по высоте
- ПО HOMATIC-control с блоком ввода данных NC2
- узел наклеивания для клея-расплава А20 для кромочных рулонов толщиной до 3 мм и отрезков толщиной до 20 мм.
- торцовка для обрезки прямо / под углом


технические данные:
- плавная подача 18-24 м/мин
- рабочая высота 950 мм
- Working width minimal: 55 mm at workpiece thickness 22 mm, 100 mm at workpiece thickness 60 mm (depending on the workpiece length)
- Workpiece overhang 30 mm
- Workpiece thickness 12 - 60 mm


- Edge material strips max. 0,4 - 20 mm
- Edge cross sectional area strips max. 900 mm2
- Edge material coil 0,3 - 3 mm
- Edge cross sectional area max.: at PVC 135 mm², at veneer 100 mm²
- Coil Ø max. 830 mm
- Pneumatic supplz 7-8 bar


Pre-milling unit
- 2 Motors each 3 kW


Workpiece pre-heating


Gluing unit A20
- Glue tank 5L
- Electronic temperature control with LED-display


- Magazine for massive edges, strip ware and coil ware


- Coil separation device


Pressure zone, autom. adjustable
- 1 driven pre-pressure rollers Ø. 150 mm
- 6 Post-pressure rollers Ø. 70 mm
Cenasf82p9


End trimming unit chamfer/straight
for workpieces with covering layer overhang up to max. 10 mm
- 2 Motors each 0,5 kW, 200 Hz., 12000 1/min.
- For trimming the edge overhangs on frontal and rear edge


Rough milling unit 1,5 KW OPTIMAT
2 Motors on eabove the other
Each 1,5 kW, 200 Hz., 12000 1/min.


Form milling units FK11 manual
To process the edge overhangs on the upper and lower workpiece edge as well to mill around the frontal and rear workpiece edge in connection with end trimming and rough milling unit.
- 2 Motors each 0,55 kW, 200 Hz., 12000 1/min.
- Holder with quick change device


- Workpiece length single sided min. 240 mm, double sided 120 mm
- Distance between workpieces min. 680 mm
- Workpiece thickness 12 - 60 mm
- at workpiece thickness over 40 mm the min. workpiece length increases to min. 230 mm
- Edge thickness max. 5 mm


Mulit-post cleaning device MN21 automatical


Post cleaning device glued joint


Buffing unit top and bottom to make the edges handy
2 motors each 0,25 kW




Note:
The specifications and descriptions are a copy of the order confirmation at that time. Datas are for information and are not binding